Introduction and Failure Scenario
The 110-story towers of the World Trade Center were designed to withstand as a whole the forces caused by a horizontal impact of a large commercial aircraft (Appendix I). So why did a total collapse occur? The cause was the dynamic consequence of the prolonged heating of the steel columns to very high temperature. The heating lowered the yield strength and caused viscoplastic (creep) buckling of the columns of the framed tube along the perimeter of the tower and of the columns in the building core.
 |
| World Trade Centre on 9/11 |
The likely scenario of failure is approximately as follows:
In stage 1 (Fig. 1), the conflagration caused by the aircraft fuel spilled into the structure causes the steel of the columns to be exposed to sustained temperatures apparently exceeding 800ŽC. The heating is probably accelerated by a loss of the protective thermal insulation of steel during the initial blast. At such temperatures, structural steel suffers a decrease of yield strength and exhibits significant viscoplastic deformation (i.e., creep—an increase of deformation under sustained load). This leads to creep buckling of columns (e.g., Baˇzant and Cedolin 1991, Sec. 9), which consequently lose their load carrying capacity (stage 2). Once more than about a half of the columns in the critical floor that is heated most suffer buckling (stage 3), the weight of the upper part of the structure above this floor can no longer be supported, and so the upper part starts falling down onto the lower part below the critical floor, gathering speed until it impacts the lower part. At that moment, the upper part has acquired an enormous kinetic energy and a significant downward velocity. The vertical impact of the mass of the upper part onto the lower part (stage 4) applies enormous
vertical dynamic load on the underlying structure, far exceeding its load capacity, even if it is not heated. This causes failure of an underlying multi-floor segment of the tower (stage 4), in which the failure of the onnections of the floor-carrying trusses to the columns is either accompanied or quickly followed by buckling of the core columns and overall buckling of the framed tube, with the buckles probably spanning the height of many floors (stage 5, at right), and the upper part possibly getting wedged inside an emptied lower part of the framed tube (stage 5, at left). The buckling is initially plastic but quickly leads to fracture in the plastic hinges. The part of building lying beneath is then impacted again by an even larger mass falling with a greater velocity, and the series of impacts and failures then proceeds all the way down (stage 5).
